In the recent introduction of the SmartDisplay product, Winstar has focused more on the function and feature itself instead of how to control it on the HOST side with the customer’s final machine. This article takes a gauge as an example, describing how to transmit and update the physical switch and HOST(Arduino) data into the SmartDisplay module.
Description
This article declares how to use a SmartDisplay CANBUS 4.3″ module in displaying 240-degree Gauge received from a host controller. The host is Arduino mega 2560 board with CANBUS shield and Rotary Angle Sensor. Required components are shown below:
1.SmartDisplay CANBUS 4.3″
2.ARDUINO Mega 2560
3.CAN-Bus Shield
4.Rotary Angle Sensor
5.CANBus Dongle
6.Software GUI-Builder
Read the full article in the link below to go through the steps
